首页 > 推广型号列表 > HCPL-2630

HCPL-2630

HCPL-2630资料
	HCPL-2630 PDF Download

File Size : 116 KB Manufacturer:FSC Description:NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Index area; a notch or pin one identification mark shall be located adjacent to pin one and shall be located within the shaded area shown. The manufacturer's identification shall not be used as a pin one identification mark. Alternatively, a tab (dim k) may be used to identify pin one. 4. Dimension Q shall be measured at the point of exit of the lead from the body. 5. This dimension allows for off-center lid, meniscus and glass overrun. 6. The basic pin spacing is .050 inch (1.25 mm) between centerlines. Each pin centerline shall be located within .005 inch (0.013 mm) of its exact longitudinal position relative to pins 1 and 14. 7. All leads - increase maximum limit by .003 inch (0.08 mm) measured at the center of the flat when the lead finish is solder. 8. Twelve spaces. 9. Applies to all four corners (leads number 2, 6, 9, and 13). 10. Dimension S 1 may be .000 inch (0.00 mm) if leads number 2, 6, 9, and 13 bend toward the cavity of the package within one lead width from the point of entry of the lead into the body or if the leads are brazed to the metallized ceramic body. 11. No organic or polymeric materials shall be molded to the bottom of the package to cover the leads. 12. Optional, see note 1. If a pin one identification mark is used in addition to this tab, the minimum limit of dimension k does not apply. 13. Applies to leads number 1, 7, 8, and 14. 14. Lead configuration is optional within dimension E, except dimensions b and C apply.


相关型号
◆ XC68HC912D60VPV8
◆ XC68HC912D60MFU8
◆ XC68HC912D60CPV8
◆ XC68HC912D60CFU8
◆ XC68HC912BD32CFU
◆ XC68HC912B32VFU8
◆ XC68HC912B32MFU8
◆ XC68HC912B32CFU8
◆ XC68HC705B32CFN
◆ XC56303VF100